Search found 45 matches

by AJD
15 Feb 2017 03:45 pm
Forum: Volvo 300 series: demand
Topic: 360 Renix Required - 414
Replies: 7
Views: 2972

Re: 360 Renix Required - 414

I'm still on the look out for a replacement Renix unit if anyone can help?

Ideally I need a 414 but may try substituting for another if none are available!
by AJD
01 Jun 2016 10:24 pm
Forum: Volvo 300 series: demand
Topic: 360 Renix Required - 414
Replies: 7
Views: 2972

Re: 360 Renix Required - 414

Thanks for the help guys – I ’d been through Mac’s (excellent) diagnostic guide and these were the results: -No spark at the coil output during cranking. -12v at the renix and a good ground. -Crank sensor resistance (160 – 280 ohms): 290 ohms Separated the coil from the renix: -Test lamp across the ...
by AJD
28 May 2016 01:11 am
Forum: Volvo 300 series: demand
Topic: 360 Renix Required - 414
Replies: 7
Views: 2972

360 Renix Required - 414

Sadly my 360 (b200k) doesn't want to start and I think I've narrowed the problem to the renix unit - does anyone have a spare?

The part number is 414 A.

Thanks!
by AJD
20 Sep 2010 11:18 pm
Forum: Volvo 300 series: demand
Topic: Drivers door central locking switch
Replies: 1
Views: 301

Drivers door central locking switch

Hi guys I need the unit that controls the central locking from the drivers door for my 360, can anyone help?
Thanks,
Alex
by AJD
30 Mar 2010 03:30 pm
Forum: Bodywork, interior, electrical equipment, accessories
Topic: interior water leaks
Replies: 6
Views: 1350

Re: interior water leaks

My 360 had a leak that came through the weather shield behind the interior door trim and then over the door seal. I was only able to find it by taking up the carpet and pouring water over the door/windscreen area. If it is still not obvious where it is coming from you could try dusting the floor pan...
by AJD
21 Nov 2009 08:05 pm
Forum: Bodywork, interior, electrical equipment, accessories
Topic: Rear doors wont open
Replies: 7
Views: 895

Re: Rear doors wont open

Ah fair enough, I'll just have to be a little more careful next time I do it. Thanks for the info!

Alex
by AJD
15 Nov 2009 08:41 pm
Forum: Bodywork, interior, electrical equipment, accessories
Topic: Rear doors wont open
Replies: 7
Views: 895

Re: Rear doors wont open

When I replaced a rear door motor the hardest part of the job was putting the door panel back on. I really struggled to get the window rubber for the quarter light back over the top of the trim, I found the only way was to push the trim down against it and use a screw driver to hook it over the top....
by AJD
10 Sep 2009 08:49 pm
Forum: Engine, transmission, manual gearbox, variomatic
Topic: Clutch cable adjustment?
Replies: 3
Views: 609

Re: Clutch cable adjustment?

Trial and error got me there in the end, not a tough job at all :)

Alex
by AJD
10 Sep 2009 05:54 pm
Forum: Engine, transmission, manual gearbox, variomatic
Topic: Clutch cable adjustment?
Replies: 3
Views: 609

Clutch cable adjustment?

I'm finding that after the car has been on the road for a while the gear change between 4th and 5th is a little crunchy, as is reverse. I think the clutch might be dragging a little bit, how do I adjust the cable to compensate for this? I’ve not done this before but I can see that the end of the clu...
by AJD
26 Aug 2009 10:59 am
Forum: General discussion; introduce yourself!
Topic: Roundabouts
Replies: 15
Views: 1116

Re: Roundabouts

I'm pretty local to the 'Magic roundabout'in Swindon and it isn't that difficult use, it was a bit intimidating when I was learning to drive though!
by AJD
10 Aug 2009 12:16 am
Forum: Bodywork, interior, electrical equipment, accessories
Topic: Earth faults
Replies: 6
Views: 647

Re: Earth faults

Where about is the earth point? I've had my instrument cluster out to repair the indicator mount so now is probably a good time for me to check! This is probably unrelated but I've found that the illumination for the head lights switch has got a very poor voltage (~0.4v), despite the rest of the swi...
by AJD
09 Aug 2009 12:54 pm
Forum: Engine, transmission, manual gearbox, variomatic
Topic: Tool for the diff filler plug
Replies: 1
Views: 474

Tool for the diff filler plug

What is the correct tool to use to remove the filler plug? It looks like the drive from a socket wrench will fit but it feels a little loose and I don’t want to round the plug off.

Alex
by AJD
16 Jul 2009 03:30 pm
Forum: Engine, transmission, manual gearbox, variomatic
Topic: Leaking diff on my 360
Replies: 7
Views: 4854

Re: Leaking diff on my 360

Bump!
Has anyone got any experience replacing the seals on the diff?
by AJD
10 Jul 2009 09:04 pm
Forum: Engine, transmission, manual gearbox, variomatic
Topic: Leaking diff on my 360
Replies: 7
Views: 4854

Leaking diff on my 360

I cleaned the diff up the other day as it seemed a bit grubby and I've discovered a leak!
There is a drop of oil on the bottom of the casing on the n/s. I'm guessing this is coming from where the drive shaft enters the differential?
How difficult is this going to be to sort out?

Cheers,
Alex
by AJD
02 Jul 2009 06:33 pm
Forum: Volvo 300 series: demand
Topic: Wing mirror & radio
Replies: 13
Views: 1770

Re: Wing mirror & radio

Sorry guys I should have updated this thread, I have managed to get hold of a mirror and a radio is in the pipeline atm.

Alex