I'm still on the look out for a replacement Renix unit if anyone can help?
Ideally I need a 414 but may try substituting for another if none are available!
Search found 45 matches
- 15 Feb 2017 03:45 pm
- Forum: Volvo 300 series: demand
- Topic: 360 Renix Required - 414
- Replies: 7
- Views: 5817
- 01 Jun 2016 10:24 pm
- Forum: Volvo 300 series: demand
- Topic: 360 Renix Required - 414
- Replies: 7
- Views: 5817
Re: 360 Renix Required - 414
Thanks for the help guys – I ’d been through Mac’s (excellent) diagnostic guide and these were the results: -No spark at the coil output during cranking. -12v at the renix and a good ground. -Crank sensor resistance (160 – 280 ohms): 290 ohms Separated the coil from the renix: -Test lamp across the ...
- 28 May 2016 01:11 am
- Forum: Volvo 300 series: demand
- Topic: 360 Renix Required - 414
- Replies: 7
- Views: 5817
360 Renix Required - 414
Sadly my 360 (b200k) doesn't want to start and I think I've narrowed the problem to the renix unit - does anyone have a spare?
The part number is 414 A.
Thanks!
The part number is 414 A.
Thanks!
- 20 Sep 2010 11:18 pm
- Forum: Volvo 300 series: demand
- Topic: Drivers door central locking switch
- Replies: 1
- Views: 924
Drivers door central locking switch
Hi guys I need the unit that controls the central locking from the drivers door for my 360, can anyone help?
Thanks,
Alex
Thanks,
Alex
- 30 Mar 2010 03:30 pm
- Forum: Bodywork, interior, electrical equipment, accessories
- Topic: interior water leaks
- Replies: 6
- Views: 2389
Re: interior water leaks
My 360 had a leak that came through the weather shield behind the interior door trim and then over the door seal. I was only able to find it by taking up the carpet and pouring water over the door/windscreen area. If it is still not obvious where it is coming from you could try dusting the floor pan...
- 21 Nov 2009 08:05 pm
- Forum: Bodywork, interior, electrical equipment, accessories
- Topic: Rear doors wont open
- Replies: 7
- Views: 2047
Re: Rear doors wont open
Ah fair enough, I'll just have to be a little more careful next time I do it. Thanks for the info!
Alex
Alex
- 15 Nov 2009 08:41 pm
- Forum: Bodywork, interior, electrical equipment, accessories
- Topic: Rear doors wont open
- Replies: 7
- Views: 2047
Re: Rear doors wont open
When I replaced a rear door motor the hardest part of the job was putting the door panel back on. I really struggled to get the window rubber for the quarter light back over the top of the trim, I found the only way was to push the trim down against it and use a screw driver to hook it over the top....
- 10 Sep 2009 08:49 pm
- Forum: Engine, transmission, manual gearbox, variomatic
- Topic: Clutch cable adjustment?
- Replies: 3
- Views: 1532
Re: Clutch cable adjustment?
Trial and error got me there in the end, not a tough job at all
Alex
Alex
- 10 Sep 2009 05:54 pm
- Forum: Engine, transmission, manual gearbox, variomatic
- Topic: Clutch cable adjustment?
- Replies: 3
- Views: 1532
Clutch cable adjustment?
I'm finding that after the car has been on the road for a while the gear change between 4th and 5th is a little crunchy, as is reverse. I think the clutch might be dragging a little bit, how do I adjust the cable to compensate for this? I’ve not done this before but I can see that the end of the clu...
- 26 Aug 2009 10:59 am
- Forum: General discussion; introduce yourself!
- Topic: Roundabouts
- Replies: 15
- Views: 3599
Re: Roundabouts
I'm pretty local to the 'Magic roundabout'in Swindon and it isn't that difficult use, it was a bit intimidating when I was learning to drive though!
- 10 Aug 2009 12:16 am
- Forum: Bodywork, interior, electrical equipment, accessories
- Topic: Earth faults
- Replies: 6
- Views: 2061
Re: Earth faults
Where about is the earth point? I've had my instrument cluster out to repair the indicator mount so now is probably a good time for me to check! This is probably unrelated but I've found that the illumination for the head lights switch has got a very poor voltage (~0.4v), despite the rest of the swi...
- 09 Aug 2009 12:54 pm
- Forum: Engine, transmission, manual gearbox, variomatic
- Topic: Tool for the diff filler plug
- Replies: 1
- Views: 1155
Tool for the diff filler plug
What is the correct tool to use to remove the filler plug? It looks like the drive from a socket wrench will fit but it feels a little loose and I don’t want to round the plug off.
Alex
Alex
- 16 Jul 2009 03:30 pm
- Forum: Engine, transmission, manual gearbox, variomatic
- Topic: Leaking diff on my 360
- Replies: 7
- Views: 8154
Re: Leaking diff on my 360
Bump!
Has anyone got any experience replacing the seals on the diff?
Has anyone got any experience replacing the seals on the diff?
- 10 Jul 2009 09:04 pm
- Forum: Engine, transmission, manual gearbox, variomatic
- Topic: Leaking diff on my 360
- Replies: 7
- Views: 8154
Leaking diff on my 360
I cleaned the diff up the other day as it seemed a bit grubby and I've discovered a leak!
There is a drop of oil on the bottom of the casing on the n/s. I'm guessing this is coming from where the drive shaft enters the differential?
How difficult is this going to be to sort out?
Cheers,
Alex
There is a drop of oil on the bottom of the casing on the n/s. I'm guessing this is coming from where the drive shaft enters the differential?
How difficult is this going to be to sort out?
Cheers,
Alex
- 02 Jul 2009 06:33 pm
- Forum: Volvo 300 series: demand
- Topic: Wing mirror & radio
- Replies: 13
- Views: 5080
Re: Wing mirror & radio
Sorry guys I should have updated this thread, I have managed to get hold of a mirror and a radio is in the pipeline atm.
Alex
Alex