I need to start working...

Post by **Carl** » 07 Feb 2006 08:27 pm

...coz my study is getting filled up with bits:

Not to mention an engine in the back of the car, plus more gauges, brake drums, wheel cylinders, exhaust and a new rad in the garage. And then there's the new exhaust manifold on its way from the good old USofA. Plus the bits I still have to order!! I hope all this work (and money) is worth it.

Post by **classicswede** » 07 Feb 2006 09:18 pm

Well where to start

Post by **volvorsport** » 07 Feb 2006 09:57 pm

exhaust manifold ?

Website · Post by **antiekeradio** » 07 Feb 2006 11:53 pm

why are you going to take the sump of?

Post by **Carl** » 08 Feb 2006 12:07 am

Because the sump on the B230 wont fit! The set should also have contained the gasket for the auxillar shaft/crank cover, but didnt

The manifold is from a 740 and has a lamda sensor hole. No idea if it'll fit, but it was only 99 cents so thought it'd be worth a try