Page 1 of 1
Opening in bell housing?
Posted: 14 Feb 2007 10:29 am
by MB1
Hey guys
I have just bought a 87' 360 GLT
theres an opening in my bell housing. I can see the pressure plate from under the car. is this normal?
Posted: 14 Feb 2007 11:29 am
by Chris_C
Is it on the top? If so it should have a sensor in it, thats the crank position sensor, so the renix ingnition knows when to spark.
Posted: 14 Feb 2007 12:01 pm
by germ
he said under the car
and i think its normal on my 1.7 i could...
Posted: 14 Feb 2007 01:18 pm
by Chris_C
Ahh, read the post first Chris...

Posted: 14 Feb 2007 03:11 pm
by SoLaMaNdA
There should be a rubber cover over the inspection hole. You could get one from a scrappy or use some gaffa tape

Posted: 15 Feb 2007 05:49 am
by dalahare
It's a big rubber cover that over the years likes to swell and soften so it won't fit properly anymore, i spent half an hour under the car trying to get it in properly, it would either pop a corner out right at the end, or slowly bulge in the middle and fall out a few seconds later, it's now in with a corner hanging out, i'd just clean it up as much as you can and use tape like Solamanda suggested.