wheel stud specifications
wheel stud specifications
I dont have anyway of measuring the thread etc of the studs on my 340, does anyone know the specs of the top of thier head?
Need to order longer ones for my spacers
also are they press fitted or threaded in
Ant
Need to order longer ones for my spacers
also are they press fitted or threaded in
Ant
-
- *** V3M DONOR ***
- Posts: 3657
- Joined: 31 Mar 2005 09:01 pm
- Location: Shropshire & Swansea, UK
- Contact:
Re: wheel stud specifications
They re 12x1.25, if you buy extended subaru impreza ones, drill the hub out to 14mm and refit them. They are pressed in, but you can wind them in with a machined spacer and a nut.
I run impreza ones on mine.
Adam
I run impreza ones on mine.
Adam
F559 LFE - 340R 2.0 16v
C208 CTR - 340 1.8 16v
D300 LBO - 360 GLT 3 Door Turbo project!! (and restoration)
F706 RBX - 350R in process!!!
C208 CTR - 340 1.8 16v
D300 LBO - 360 GLT 3 Door Turbo project!! (and restoration)
F706 RBX - 350R in process!!!
Re: wheel stud specifications
do i have to use subaru ones or can i just hi jack deom tweeks for whatever they have?
-
- Posts: 120
- Joined: 28 Nov 2007 10:06 pm
- Location: Netherlands
Re: wheel stud specifications
No they are M12 x 1.50340GLT wrote:They re 12x1.25,
Understeer: The front of the car hits the wall,
Oversteer: The rear of the car hits the wall,
Horsepower: How fast the car hits the wall,
Torque: How far the car pushes the wall.
-
- *** V3M DONOR ***
- Posts: 9143
- Joined: 11 Nov 2008 04:22 pm
- Location: Newcastle Upon Toon
Re: wheel stud specifications
mine are 1.25 like.2 Fast 4 U wrote:No they are M12 x 1.50340GLT wrote:They re 12x1.25,
-
- Posts: 120
- Joined: 28 Nov 2007 10:06 pm
- Location: Netherlands
Re: wheel stud specifications
I just measured them and they are indeed M12 x 1.25 sorry
Understeer: The front of the car hits the wall,
Oversteer: The rear of the car hits the wall,
Horsepower: How fast the car hits the wall,
Torque: How far the car pushes the wall.
Re: wheel stud specifications
so I have bought extended subaru ones, do i just need a 14mm drill bit drill the hubs then bash em in with a hammer and a bit of heat and lock tight?
-
- Posts: 1921
- Joined: 06 Dec 2008 09:35 pm
- Location: Netherlands.
- Contact:
Re: wheel stud specifications
yep, apart from beating them in with a hammer...
just use a spacer and a nut to get them in
just use a spacer and a nut to get them in
Re: wheel stud specifications
so i effectively pull them through using the nut against the spacer?
-
- Posts: 1921
- Joined: 06 Dec 2008 09:35 pm
- Location: Netherlands.
- Contact: