SERVO?
SERVO?
My brakes have suddenly become much harder! The pedal is very hard with the engine off (after pumping to remove the vacuum), then it drops a bit with the engine on and assistance from the servo but the brakes feel considerably harder than before? Is it possible that the Servo's on its way out? I replaced the brake shoes about 6 weeks ago so it maybe down to them self-adjusting with wear leading to harder feeling brakes?...
1988 340 1.4 DL
(I suffer with O.C.D. which makes me obsessed with fine detail)
(Diagrams or photos are far more helpful to me when it comes to cars)
(I suffer with O.C.D. which makes me obsessed with fine detail)
(Diagrams or photos are far more helpful to me when it comes to cars)
Re: SERVO?
which car?
Servo sounds fine, have you checked the fronts? Calliper slider pins moving freely? rear adjusters stuck?
Servo sounds fine, have you checked the fronts? Calliper slider pins moving freely? rear adjusters stuck?
1980 345 DL_______1987 360 GLE (project car restored to GLT spec and B230FT'd)
1984 360 GLT______1987 360 GLT
1983 360 GLS______1989 360 GLE
1985 340 GL_______1986 340 1.4
1985 360 GLS______1995 940 SE 2.3 Turbo Estate (daily)
1987 340 GL 1.7
1984 360 GLT______1987 360 GLT
1983 360 GLS______1989 360 GLE
1985 340 GL_______1986 340 1.4
1985 360 GLS______1995 940 SE 2.3 Turbo Estate (daily)
1987 340 GL 1.7
Re: SERVO?
Volvo 340DL 1.4 1988
I checked the rear adjusters today and they're moving ok although the offside one isnt as rigid in its slot ie;its moving from left to right inside the hole it sits in and doesnt appear to be able to self adjust as its not coming into contact with the fixed serated small drum/disc! Why would this be as the spring below it is in place?...
I checked the rear adjusters today and they're moving ok although the offside one isnt as rigid in its slot ie;its moving from left to right inside the hole it sits in and doesnt appear to be able to self adjust as its not coming into contact with the fixed serated small drum/disc! Why would this be as the spring below it is in place?...
1988 340 1.4 DL
(I suffer with O.C.D. which makes me obsessed with fine detail)
(Diagrams or photos are far more helpful to me when it comes to cars)
(I suffer with O.C.D. which makes me obsessed with fine detail)
(Diagrams or photos are far more helpful to me when it comes to cars)
Re: SERVO?
I had a similar problem with my 340 recently.
What had happened is that the vacuum take off pipe for the servo had collapsed internally.
There is basically a small section of flexible rubber hose at the end of pipe which connects to the manifold. Have a check of that and make sure it's clear.
Hope that helps.
What had happened is that the vacuum take off pipe for the servo had collapsed internally.
There is basically a small section of flexible rubber hose at the end of pipe which connects to the manifold. Have a check of that and make sure it's clear.
Hope that helps.
“the winner ain't the one with the fastest car, it's the one who refuses to lose” - Dale Earnhardt