Soo the wheel came loose while i was driving and it came off and snapped one of the studs
Volvo dont make them anymore and i dont know where to get some :/
Anyone know where to get some or where to get alternative ones that are the same??
Regards Jordan
Wheel stud snapped!!
Re: Wheel stud snapped!!
Subaru ones off ebay, they are longer but you can cut them down
'88 360 +T LSD - sold
'87 760 TDI (D24TIC) - sold
'04 V40 D sport (F9Q, decat, Remapped, launch control)
'89 740 SE (b230ft, 12psi, V-cam, headwork, 'remapped', banded steels)
'86 340 DL 1.4
'87 760 TDI (D24TIC) - sold
'04 V40 D sport (F9Q, decat, Remapped, launch control)
'89 740 SE (b230ft, 12psi, V-cam, headwork, 'remapped', banded steels)
'86 340 DL 1.4
Re: Wheel stud snapped!!
Front or rear?
Rear is a wheel bearing change requirement aswell, as you need to destroy the wheel bearing to remove the flange. Definately for the later type, not sure about multipiece bearings.
Front might be simpler to get a replacement hub, same applies to rear, but you need the hub/flange and backplate all together if you want to avoid rear wheel bearing change.
Rear is a wheel bearing change requirement aswell, as you need to destroy the wheel bearing to remove the flange. Definately for the later type, not sure about multipiece bearings.
Front might be simpler to get a replacement hub, same applies to rear, but you need the hub/flange and backplate all together if you want to avoid rear wheel bearing change.
1980 345 DL_______1987 360 GLE (project car restored to GLT spec and B230FT'd)
1984 360 GLT______1987 360 GLT
1983 360 GLS______1989 360 GLE
1985 340 GL_______1986 340 1.4
1985 360 GLS______1995 940 SE 2.3 Turbo Estate (daily)
1987 340 GL 1.7
1984 360 GLT______1987 360 GLT
1983 360 GLS______1989 360 GLE
1985 340 GL_______1986 340 1.4
1985 360 GLS______1995 940 SE 2.3 Turbo Estate (daily)
1987 340 GL 1.7
-
- Posts: 38
- Joined: 26 Jan 2012 06:28 pm
Re: Wheel stud snapped!!
Its a front one ! getting parts for these is harder than finding a pot of gold at the end of a rainbow :L
Re: Wheel stud snapped!!
It's not that hard, you just have to put some thought into it. The only thing that we don't have a lot of is panels.