tightening track rod end
tightening track rod end
how do you tighten it fully, it just keeps spinning round
Re: tightening track rod end
Hello, some some of the track rods have a bit with a hexagonal cross-section which you can pop a spanner onto but failing that then I guess mole-grips would do it or I think I used a whopping pair of water-pump spanners for mine.
1988 340 1.4 GL, 218k, 5 door (Grey Bess). Gone to CBA.
1991 340 1.7 GL, 64k, 5 door, petrol blue (Deep Blue).
1988 360 2.0 GLE, 140k, 5 door, ocean blue metallic (Blue Bess).
1989 340 1.7 GL, 108k, 3 door (Red Ness).
More info here!
1991 340 1.7 GL, 64k, 5 door, petrol blue (Deep Blue).
1988 360 2.0 GLE, 140k, 5 door, ocean blue metallic (Blue Bess).
1989 340 1.7 GL, 108k, 3 door (Red Ness).
More info here!
Re: tightening track rod end
the answer to this problem if any one ever needs is to jack the track rod end up from the bottom
Re: tightening track rod end
Thats the one! Aswell as clean the threads and lubricate.frazeb wrote:the answer to this problem if any one ever needs is to jack the track rod end up from the bottom
1980 345 DL_______1987 360 GLE (project car restored to GLT spec and B230FT'd)
1984 360 GLT______1987 360 GLT
1983 360 GLS______1989 360 GLE
1985 340 GL_______1986 340 1.4
1985 360 GLS______1995 940 SE 2.3 Turbo Estate (daily)
1987 340 GL 1.7
1984 360 GLT______1987 360 GLT
1983 360 GLS______1989 360 GLE
1985 340 GL_______1986 340 1.4
1985 360 GLS______1995 940 SE 2.3 Turbo Estate (daily)
1987 340 GL 1.7