Took my handle out earlier... It'd fallen apart a bit but it's fixed now (the pivot bit that pulls the door opening rod had fallen out).
Problem is, I'm not so sure how to get it back in again? All I removed was the inside door card and then undid the screw holding the handle in and slid the plastic cover out of the way.
Can't seem to get it back in though! I'm wondering if I need to attach the rods first (seems like it'd be very difficult!) and then put the whole thing in, or if I need to put it in and then attach the rods; Which seems impossible (fat hands).
Any tips? Need to get it sorted tomorrow if possible...
Thanks:)
How to get my door handle back in? - '88 1.7 340.
Re: How to get my door handle back in? - '88 1.7 340.
Just to add: Drivers door, on a 5 door car:)
Re: How to get my door handle back in? - '88 1.7 340.
Yes you need to attach the rods and feed them in first, ie attach the rods to the handle not the lock. It is nearly impossible to get the clips on the handle once its in, much easier to pop in the lock end which is just a plastic holder.
1980 345 DL_______1987 360 GLE (project car restored to GLT spec and B230FT'd)
1984 360 GLT______1987 360 GLT
1983 360 GLS______1989 360 GLE
1985 340 GL_______1986 340 1.4
1985 360 GLS______1995 940 SE 2.3 Turbo Estate (daily)
1987 340 GL 1.7
1984 360 GLT______1987 360 GLT
1983 360 GLS______1989 360 GLE
1985 340 GL_______1986 340 1.4
1985 360 GLS______1995 940 SE 2.3 Turbo Estate (daily)
1987 340 GL 1.7
Re: How to get my door handle back in? - '88 1.7 340.
I didn't attach the rods first, but make sure they are pointing downwards (if they are on the doorhandle itslef)
And then patience and a lot of wobbling, there's a trick in it which you have to find out by doing it
And then patience and a lot of wobbling, there's a trick in it which you have to find out by doing it
Last edited by Vermilion on 06 Oct 2010 11:12 am, edited 1 time in total.
Volvo 340 L 1983
Re: How to get my door handle back in? - '88 1.7 340.
Ahh cool... So far I've been trying with the rods attached to the door lock thing, not the handle.. I'll try the other way round this afternoon; Rods attached to handle, dangled down into door, and clipped into place at the bottom (lock) end.
Thanks:)
Thanks:)
Re: How to get my door handle back in? - '88 1.7 340.
Got it back in just now... Rods attached to handle and dangled down, then clipped into their places on the door mech thing.Had to undo the nut at the bottom of the window channel and pull it out of the way too, it was right in the way of the lower rod attaching bits. Fiddley job!
Thanks:)
Thanks:)