Can anyone help me out!!!!!
-
- Posts: 65
- Joined: 09 May 2012 10:46 pm
Can anyone help me out!!!!!
Hi all I have a set of vdo gauges oil temp and pressure and I want to fit them to my redblock b200 engine. Where do I start and what do I need? I have a sender for the pressure gauge but where do I fit it on the engine and I need a sender for the temp and where would I fit that one as well. Would be great if anyone can help me out thanks
Re: Can anyone help me out!!!!!
You can use an adaptor on the oil pressure switch for the pressure sender, you need to know the threads. The block is tapped for M14 I think.
There may also be a hole just under the front of the head for it, but requires an angled adaptor depending on the thread.
The temperature sender is not so easy, you need to modify the sump plug or the sump. You need to measure the oil temp in the sump.
There may also be a hole just under the front of the head for it, but requires an angled adaptor depending on the thread.
The temperature sender is not so easy, you need to modify the sump plug or the sump. You need to measure the oil temp in the sump.
1980 345 DL_______1987 360 GLE (project car restored to GLT spec and B230FT'd)
1984 360 GLT______1987 360 GLT
1983 360 GLS______1989 360 GLE
1985 340 GL_______1986 340 1.4
1985 360 GLS______1995 940 SE 2.3 Turbo Estate (daily)
1987 340 GL 1.7
1984 360 GLT______1987 360 GLT
1983 360 GLS______1989 360 GLE
1985 340 GL_______1986 340 1.4
1985 360 GLS______1995 940 SE 2.3 Turbo Estate (daily)
1987 340 GL 1.7