Rust problems and repairs, leaky sunroof... Battery, starter, lights, fuses, airco, heating unit, stereo... | Tuning: custom spoilers & bodykits, fiberglass parts...
NO parts requests here, please use our V3M BUY & SELL corner
-
benji1985
- Posts: 503
- Joined: 30 Oct 2015 06:58 pm
- Location: Helston
Post
by benji1985 » 22 Apr 2016 02:32 pm
Hello all, I was wondering if there has been a "how to" on removing the whole dash board from the 340, if there is can someone point me to it please, or can explain how to do it, just thinking in advanced
Ben
-
Ride_on
- Posts: 2265
- Joined: 26 May 2009 05:34 pm
- Location: Belfast, N. Ireland
Post
by Ride_on » 22 Apr 2016 07:28 pm
I'm sure it has been covered but its really not hard.
instrument panel + switch connections
Steering wheel
radio
tunnel consol
pop off the heater ducts
4 bolts at the sides
2 bolt on tunnel hoop
2 screws bottom of centre consol
4 screws in radio bay
Slides out leaving the centre controls+ashtray etc
The heater ducts are the most difficult, give the a good firm wiggle
1980 345 DL_______1987 360 GLE (project car restored to GLT spec and B230FT'd)
1984 360 GLT______1987 360 GLT
1983 360 GLS______1989 360 GLE
1985 340 GL_______1986 340 1.4
1985 360 GLS______1995 940 SE 2.3 Turbo Estate (daily)
1987 340 GL 1.7
-
benji1985
- Posts: 503
- Joined: 30 Oct 2015 06:58 pm
- Location: Helston
Post
by benji1985 » 22 Apr 2016 08:01 pm
Ride_on wrote:I'm sure it has been covered but its really not hard.
instrument panel + switch connections
Steering wheel
radio
tunnel consol
pop off the heater ducts
4 bolts at the sides
2 bolt on tunnel hoop
2 screws bottom of centre consol
4 screws in radio bay
Slides out leaving the centre controls+ashtray etc
The heater ducts are the most difficult, give the a good firm wiggle
that easy? nice i'll have a look when the time comes thank you
Ben