Hello all
Did anybody fit auto gearbox from other models?
I think that gearbox from any redblock could be fitted to B19A?
May be I'm a bit crazy:)
Automatic gearbox
Re: Automatic gearbox
I've though about this before but arent sure there is adaquate room behind the bellhousing for a gearbox if it were installed as per the 240, 740 etc.
with some bespoke mounts maybe one could be mounted where the gearbox usually sits at the back? A bespoke gear linkage would also be needed.
regards
S
with some bespoke mounts maybe one could be mounted where the gearbox usually sits at the back? A bespoke gear linkage would also be needed.
regards
S
Enjoy your 300s
Re: Automatic gearbox
Gear linkage would work from a 2/7/9 with some cutting. Your main problem is fitting a completely different rear axle/diff/suspension.
'89(G) 340 GLE B172k
'03 S60 D5 SE, '91 (J) MX5, 1954 Cyclemaster
Ex:
'89(F) 340 GL F7R (ex B172k) - Fake -> SBKV 300 Runner Up 08, 12; '91(H) 340 GL B14.4E - Kar; '88(F) 360 GLT B200E - Jet -> BKV 300 Runner Up 09; '89(G) 360 GLT B200E - Beast
'03 S60 D5 SE, '91 (J) MX5, 1954 Cyclemaster
Ex:
'89(F) 340 GL F7R (ex B172k) - Fake -> SBKV 300 Runner Up 08, 12; '91(H) 340 GL B14.4E - Kar; '88(F) 360 GLT B200E - Jet -> BKV 300 Runner Up 09; '89(G) 360 GLT B200E - Beast
Re: Automatic gearbox
Fitting an AT in the back is next to impossible. Where are you going to put the torque converter?
Re: Automatic gearbox
Fitting to the back is not a case for me..
I have some crazy idea about tuning, but don't know when I will do it..
So if it is possible to place gearbox in the front, then it is ok
thanks for your replies!
I have some crazy idea about tuning, but don't know when I will do it..
So if it is possible to place gearbox in the front, then it is ok
thanks for your replies!
'84 360