Where is the mixture adjusting skrews?

Post by **kloppen** » 17 Feb 2005 02:08 pm

I don't think I would do that... Then I risk to destroy the engine. It's a bit old and have nearly run for 500 000 km.

Post by **foggyjames** » 17 Feb 2005 11:18 pm

The only thing that can really go wrong is if the timing belt / tensioner is old, and the belt breaks. The engine benefits from some hard work once in a while.

cheers

James

Post by **foggyjames** » 24 Feb 2005 12:48 am

Here is the mixture screw hole...

cheers

James

Post by **jtbo** » 24 Feb 2005 07:01 am

There is one wire at top right in your picture, where is it connected in a carb?

I ask because it is loose in my car and I have not found anything where to put it.

Post by **foggyjames** » 24 Feb 2005 10:40 am

Errrrr...I'll have a look!

cheers

James

Post by **jtbo** » 25 Feb 2005 08:15 pm

Thank you, I'll be changing various parts randomly into my car tomorrow, let's see if it runs afterwards