Volvo 340 B172 Feb 1988 Acceleration Anomaly
Volvo 340 B172 Feb 1988 Acceleration Anomaly
funky acceleration issue, instead of accelleration being a "straight curve", its wavy.. proper funky feeling.
any ideas.. this is a new one on me.
The more I press the accelerator the more it boings, its not under fuelleling, no misfires, its totally smooth, just boingy.
only does it occasionally.
could it be under fuelling.. I dunno.
boing..
seizing component...
feels renixey.. , air leak somewhere.
boing.. timing +-...
cyclic vacuum+-'ing
any ideas.. this is a new one on me.
The more I press the accelerator the more it boings, its not under fuelleling, no misfires, its totally smooth, just boingy.
only does it occasionally.
could it be under fuelling.. I dunno.
boing..
seizing component...
feels renixey.. , air leak somewhere.
boing.. timing +-...
cyclic vacuum+-'ing
Re: Volvo 340 B172 Feb 1988 Acceleration Anomaly
Sounds like the zebedee effect.
Does it mainly happen on roundabouts?
Does it mainly happen on roundabouts?
Keeper of The Knights' of Bushido-lest we forget
Write it in your heart.
Stand by the code and it will stand by you.
Ask no more and give no less than honesty,courage,loyalty,generosity and fairness.
The code of the West.
Write it in your heart.
Stand by the code and it will stand by you.
Ask no more and give no less than honesty,courage,loyalty,generosity and fairness.
The code of the West.
-
- *** V3M DONOR ***
- Posts: 9143
- Joined: 11 Nov 2008 04:22 pm
- Location: Newcastle Upon Toon
Re: Volvo 340 B172 Feb 1988 Acceleration Anomaly
hmm... all is good airwise, maybe I was lower of fuel than I thought.
not done it since..
not done it since..
Re: Volvo 340 B172 Feb 1988 Acceleration Anomaly
Got it again.... zebedee effect.
It's down to a battered renix, need one.
It's down to a battered renix, need one.
Re: Volvo 340 B172 Feb 1988 Acceleration Anomaly
Mine used to do a thing that felt like it was either full throttle or nothing, I guess that could be described as bouncy? Turned out it was a knackered crank sensor that was no longer waterproof.
'89(G) 340 GLE B172k
'03 S60 D5 SE, '91 (J) MX5, 1954 Cyclemaster
Ex:
'89(F) 340 GL F7R (ex B172k) - Fake -> SBKV 300 Runner Up 08, 12; '91(H) 340 GL B14.4E - Kar; '88(F) 360 GLT B200E - Jet -> BKV 300 Runner Up 09; '89(G) 360 GLT B200E - Beast
'03 S60 D5 SE, '91 (J) MX5, 1954 Cyclemaster
Ex:
'89(F) 340 GL F7R (ex B172k) - Fake -> SBKV 300 Runner Up 08, 12; '91(H) 340 GL B14.4E - Kar; '88(F) 360 GLT B200E - Jet -> BKV 300 Runner Up 09; '89(G) 360 GLT B200E - Beast
Re: Volvo 340 B172 Feb 1988 Acceleration Anomaly
I'm stripping out the whole 'ignition system', it could be vacuum leak or its a ruined vac-sensor on the renix(does appear that way...) Shall know soon
Re: Volvo 340 B172 Feb 1988 Acceleration Anomaly
This bit of old, split, perished, manky, cannibalised coolant pipe was my brake servo pipe 'connector adaptor'. Interestingly- The servo pipe fits the manifold perfectly without it. - now looking for the shortened coolant hose.....
It ticks over properly now and starts a damn sight easier when warm, doesn't surge and wane all the time - Win!
Botch-e-lism, gets everywhere....
It ticks over properly now and starts a damn sight easier when warm, doesn't surge and wane all the time - Win!
Botch-e-lism, gets everywhere....
Re: Volvo 340 B172 Feb 1988 Acceleration Anomaly
Still have a hunting tickover and occasional surging/waning at partial throttle.
I'm going to disconnect the vacuum to the renix+block the pipe.. somehow I don't think it is the renix though..
Any ideas/methods to eliminate/hunt down the cause would be handy right now.
I know my dizzy+cap is tip-top.
Fuel delivery is fine.
Carb I'm not sure about.
I'm going to disconnect the vacuum to the renix+block the pipe.. somehow I don't think it is the renix though..
Any ideas/methods to eliminate/hunt down the cause would be handy right now.
I know my dizzy+cap is tip-top.
Fuel delivery is fine.
Carb I'm not sure about.
Re: Volvo 340 B172 Feb 1988 Acceleration Anomaly
Should not afftect tick over unless its leaking. I'd suggest you block/pinch all the breathers. Another method is to spray WD40 around any joints and see if the tick over changes.
1980 345 DL_______1987 360 GLE (project car restored to GLT spec and B230FT'd)
1984 360 GLT______1987 360 GLT
1983 360 GLS______1989 360 GLE
1985 340 GL_______1986 340 1.4
1985 360 GLS______1995 940 SE 2.3 Turbo Estate (daily)
1987 340 GL 1.7
1984 360 GLT______1987 360 GLT
1983 360 GLS______1989 360 GLE
1985 340 GL_______1986 340 1.4
1985 360 GLS______1995 940 SE 2.3 Turbo Estate (daily)
1987 340 GL 1.7
-
- Posts: 3283
- Joined: 09 Feb 2008 02:29 am
Re: Volvo 340 B172 Feb 1988 Acceleration Anomaly
I do remember my saloon doing over 40mpg on a run - this one is not.. more like 10!
It needs a proper revamp under the bonnet to get the economy back: I've got some bits of new vac/breather hose knocking about luckily
Clean everything + check everything = win.
Have a bit of gasket-in-a-tube to plug leaks temporarily, see if it will run right first.
But... the carburettor - it needs a rebuild too after the 150k, standing for ages n stuff - might rejet it for modern shitty air+petrol while I'm at it. Bendy Carb pmsl! I can have the carb and manifold resurfaced very cheaply if it's warped, and gasket-sealant it to test - cheers.
Procrastinating with 3 hours of daylight left.....
b******s to it! only got 'A' bit of sanding to do before g3 cut and a light coat of fresh paint all over. Welding is done tomorrow(hope it's not lapwelded..). Will get the mot eventually... why drive it in this crap weather, skin myself etc anyway? I deserve a rest (tells self "I am not a salmon!").
It needs a proper revamp under the bonnet to get the economy back: I've got some bits of new vac/breather hose knocking about luckily
Clean everything + check everything = win.
Have a bit of gasket-in-a-tube to plug leaks temporarily, see if it will run right first.
But... the carburettor - it needs a rebuild too after the 150k, standing for ages n stuff - might rejet it for modern shitty air+petrol while I'm at it. Bendy Carb pmsl! I can have the carb and manifold resurfaced very cheaply if it's warped, and gasket-sealant it to test - cheers.
Procrastinating with 3 hours of daylight left.....
b******s to it! only got 'A' bit of sanding to do before g3 cut and a light coat of fresh paint all over. Welding is done tomorrow(hope it's not lapwelded..). Will get the mot eventually... why drive it in this crap weather, skin myself etc anyway? I deserve a rest (tells self "I am not a salmon!").
Re: Volvo 340 B172 Feb 1988 Acceleration Anomaly
Postponed MOT to do more bodywork etc.
Got quite a bad propshaft rattle and vibration, what parts?
Got quite a bad propshaft rattle and vibration, what parts?