Page 1 of 1

940 Turbo

Posted: 03 Feb 2014 07:24 pm
by Mcglone7
Hello,

does anyone know what the thread is on the 940 turbo's for oil inlet/outlet. Also the same for water feed too.

Re: 940 Turbo

Posted: 03 Feb 2014 08:41 pm
by classicswede
The oil filter is 3/4 unf iirc


If you are on about the fittings on the turbo, the water connections are bolt on fittings. Not sure what the oil feed and return threads are off the top of my head but they are a standard thread common to most turbos.

Re: 940 Turbo

Posted: 03 Feb 2014 08:50 pm
by Mcglone7
Cheers for that, i think i've found it on ebay. 12.5mm common banjo bolt size.

Re: 940 Turbo

Posted: 07 Feb 2014 11:38 am
by Nimminz
m12 x 1.5 pitch banjo's

Re: 940 Turbo

Posted: 19 Feb 2014 11:01 pm
by filthyjohn
The oil outlet is a plain pipe with a bolt either side and a gasket.