Hi

Sorry this is like spam but I left the haynes manual for the 360 at my student house. I'm picking up a exhaust center section tomorrow and need to know what rubbers to pick up to mount the center section and the backbox - anyone know off the top of their head, as when my friends took it off there was a really thick one on the backbox, I thought the rubbers were a standard size but obviously not.

Regards

Marlon

Marlon never confuse asking for help with spamming.

pop into kwikfit , act a bit dumb and they will probably give you the rubbers free of charge , it always works for me.

(no comments about having an advantage in the acting dumb department)

Halfrauds also stock the required rubbers - they even have polyurethane ones if you want to be flash - I just reused the rubbers that were already on it.

For the back box you need two rings:



and one of these:



Don't know about the centre section - didn't look at it too closely

The mid box doesn't use rubber hangers...it uses a number of thin sheets of metal to form a brace to a bracket on the torque tube.

cheers

James