Page 1 of 1

f7r\p backwards manifold

Posted: 12 Nov 2012 01:47 pm
by tattooer
going bike carbs so not needed, done to a very high standard,
140ono item in chatham kent pick up ideally 07936384390 jake-

Re: f7r\p backwards manifold

Posted: 15 Nov 2012 09:13 pm
by tattooer
must be abit pricey? 120ono...

Re: f7r\p backwards manifold

Posted: 16 Nov 2012 11:31 am
by Chris_C
Got a picture? Cut and welded on the flange or cut the end off one side and put it on the other?

Re: f7r\p backwards manifold

Posted: 16 Nov 2012 12:02 pm
by theo2468
Yeah how well has it been done? I'm sure speedys manifold was the problem of his running

Re: f7r\p backwards manifold

Posted: 16 Nov 2012 01:58 pm
by Speedy88
Nah my running problem was due to a loom problem with the intake temp sensor. Adam swore by the design, not to mention he had it running perfectly for years before it went into my car.

Re: f7r\p backwards manifold

Posted: 16 Nov 2012 04:48 pm
by bmiles
The welds look like been done by a pro .

Re: f7r\p backwards manifold

Posted: 17 Nov 2012 11:27 am
by tattooer
Will get pic asap. But it no messabout. The welds are perfect !

Re: f7r\p backwards manifold

Posted: 25 Nov 2012 09:30 am
by filthyjohn
I don't think people are asking about the quality of the welds, I think they're asking where on the manifold they are, four of them on the inlet runners or one big one after the throttle body?

Re: f7r\p backwards manifold

Posted: 25 Nov 2012 01:14 pm
by Chris_C
filthyjohn wrote:I don't think people are asking about the quality of the welds, I think they're asking where on the manifold they are, four of them on the inlet runners or one big one after the throttle body?
Much better put than I managed!

Re: f7r\p backwards manifold

Posted: 26 Nov 2012 10:30 pm
by classicswede
From memory I think the manifolds Adam had done were with the throttle plate cut and welded onto other end rather the cut on the runners.

Re: f7r\p backwards manifold

Posted: 27 Nov 2012 10:31 am
by bmiles
That how this one has been done