Decided to break my 1.7GL as I need to get my classic ford on the road and this 340 will just take too much time to weld up.
Bodywork is very bad on the rear arches, inner rear arches and rear wheel tubs inside the car.
Front wings aren't great.

Rear doors, rear interior and diff spoken for but everything else is available.
81K miles, drives and runs great and pretty much everything works.
Has lowering springs and blocks fitted.

Located in perthshire, scotland but can post anything including engine.

Parts available -



£4



£3



Engine bay loom inc fusebox - £10



Rubber gear gaiter - £3



Glovebox with light and wiring - £7.50



Coolant valve for heater - £3



£2 - no key



Boot seal - £5



Interior plastic trim - £7 for the set



Bendix coil - £6



Dash wiring loom inc relays - £10



£5



£2



£10



£7.50 no key with ignition barrel



£3.50



Drivers side - £2



£10 recently new part with part number sticker still on



£7 for both



£9 for both not inc speakers but does include speaker grills



£7



£5



£4



£5



£10

All prices plus postage.

.

Pm sent about headlights and grille

.

Engine now including everything minus dizzy and carb for £60.
Can put on a pallet no problem.

I could do with the sun visors!

Im after the little white plastic connector between the clutch pedal, and the cable
price posted please.

Seb, just to say, volvo 440s have a similar design that fits well, but it's metal. I snapped my plastic one a while ago so needed to replace it. the metal one is obviously a lot stronger!

.

.

.

Offers on most things welcome.

Hi there.

Would you send just the plastic bolt covers from the front bumper?

Some arse has knicked mine

A big ask but what would be the postage to NZ for the rubber mats please.

Havin-a-tug wrote:Hi there.

Would you send just the plastic bolt covers from the front bumper?

Some arse has knicked mine

Afraid the bumper is gone with the caps still on.

I don't mind posting to NZ at all, though it might be pricey.