Needing a diff output flange for my 360... (but 340 is just the same so I've since found out!)

One would be good, two would be perfect!

Anyone?

Anyone know if this is shared with models other than the 2.0 360?

Diff output? Good luck dude, you're better off trying to find a complete diff. Nobody has half broken diffs lying around unfortunately

To answer your question, I'm not 100% on this but yes I believe they are the same across the board, 340 and 360.

Well either this or a complete diff.
Need to get the car back up and running!

Pretty sure they are all the same but there are 2 part numbers in the -'85 catalogue

3284959 - 8 -> Up to Chassis # 597180
3296509 - 7 -> B14 M45R ch. # 826226 onwards
-> B14 M47R ch. # 825898 onwards
-> B19 M45R ch. # 825898 onwards
-> B19 M47R ch. # 826716 onwards

But in the -'91 catalogue there is only the latter mentioned so I'd presume they all fit all diffs.

I'm guessing the earlier one is the one with a recess machined in for a gasket like the CVT's have. They used to use em on the MT diffs for a while i think. So presumably they'd fit but you'd need gaskets for them too.

Hope that helps
Matt

Is this a part that is likely to be source-able from a factors or Volvo? Or is this going to be a used part only?

I tried at my local volvo dealer and he said they were no longer available.
Doubt a factors would stock such a part, if any company ever re-manufactured them other than volvo.
Best bet's a used diff - even one that's buggered - as long as those parts are ok.

Thought that might be the case.

Happy to pay decent money for one (or preferably two!) posted to Glasgow.

Have you managed to find one as yet? If not I should have a complete diff.

Nope, sent out tons of emails, but nothing sourced as yet.

Ideally 2 flanges would be great so I have a spare sitting.

Will consider a whole diff if it comes to it....

I do have a spares car so could remove and post, would be faster to send as a complete diff unit.

Just let me know how much!

PM sent