Hi all, I'm looking for the following parts....

AC/Heater fan blower motor - No longer needed, found one from a Toyota landcruiser that fits perfectly.

Bottom radiator hose - No longer needed, found one to suit.
Fuel pump, closest to fuel tank - does anyone know the model number?

I'm sure I'll be needing some more bits and pieces, so will post them in here.

EDIT 1: Also still looking for the rectangular trim that fits around the inside (right) door handle. EDIT: finally got a picture of what I mean...



2 x front bumper "plugs" oval shaped, that cover bolt holes - no longer needed, THANK-YOU TOM

EDIT 2: Does anyone have a snowcap? Or the measurements/specs and how it attaches to the car? (I'm getting to be quite handy with fibreglass and like a challenge)

EDIT 3: Interior rear-view mirror -The list is getting longer by the day... - No longer needed.

Thanks for looking.


All of the above are for a 1985 360 GLT B200E 5 door hatch....bottomless hole that eats money!

Figgy wrote:2 front bumper "plugs" oval shaped, that cover bolt holes

I think I have some of these, bottom left in the picture.


Can't imagine postage will be much, even to Aus. If you're out of luck locally, drop me a PM in a week or so ...

Tom

Thanks Tom, bottom left in the picture is the exact thing I'm looking for. I will do that and pm you in about a week, I've had no luck locally....so far.

OK, forget the week. I just checked postage and it amounts to 2 Euros air mail

The question is, which bolt covers exactly do you need? There is a slight difference. In the middle of the rear side of the cover there's either a "1" or a "2", depending which way around you're holding it there's a plastic lug (?) is either on the left or on the right hand side.

Tom

trabitom99 wrote:OK, forget the week. I just checked postage and it amounts to 2 Euros air mail

The question is, which bolt covers exactly do you need? There is a slight difference. In the middle of the rear side of the cover there's either a "1" or a "2", depending which way around you're holding it there's a plastic lug (?) is either on the left or on the right hand side.

Tom

I've just taken off the 2 that I have here, one from each side and they're the same on the back They have the numbers that follow.... 296 334 on the top line and 84 660 on the bottom line.
When holding it the right way up/as it fits in the car and looking at the back there is one wide clip at the top and two smaller clips at the bottom and the little "lug" or little peg is on the right.
I hope this helps to clarify and not confuse the issue?

Figgy wrote:They have the numbers that follow.... 296 334 on the top line and 84 660 on the bottom line.

... that's it, and in the middle, there's a very small small "2" ?

Figgy wrote:When holding it the right way up/as it fits in the car and looking at the back there is one wide clip at the top and two smaller clips at the bottom and the little "lug" or little peg is on the right.

I have two of the above, but also two where the little peg is on the left (held the same way up as you are describing). The version with the peg on the left has a small "1" in the middle.

Since you seem to have two "2"s I'd guess you need two "1"s

Tom

Tom, I've just had another look, with a magnifying glass this time, yes they have a tiny "2" in the middle, one has had a screwdriver poked right through it at some stage. (why would someone do that, when there's clearly little slots to lever them out )

I wonder how much 2 euros is in Aussie dollars? Not much at all I imagine, so how do I pay you? I have a paypal account that I use for eBAy, but I've heard the fees are rather high for the person getting the payment, so that might not be the best option?

Figgy wrote:Tom, I've just had another look, with a magnifying glass this time, yes they have a tiny "2" in the middle, one has had a screwdriver poked right through it at some stage. (why would someone do that, when there's clearly little slots to lever them out )

Perhaps you could try fitting the "2"s into the missing holes? Do they fit, or do they look like the peg should be on the other side (like the "1"s)? I've never had a Mk2 so I don't really know which hole gets which cover.

On the Mk3 the (longer shaped) bumper bolt covers look similar, but they are different for the left and right hand side of the car. If you fit the wrong ones, the fit isn't so good and they tend to fly off.

Figgy wrote:I wonder how much 2 euros is in Aussie dollars? Not much at all I imagine, so how do I pay you? I have a paypal account that I use for eBAy, but I've heard the fees are rather high for the person getting the payment, so that might not be the best option?

Google says it's about $3.25. Don't worry about the PayPal fees, they're a percentage of the amount. Round it up to $3.50 and then that's OK

I'll pop them in the post for you as soon as we figure out which hole covers you need (maybe another MkII owner can help here?)

Tom

They seem to fit neatly in any hole, maybe I should get a 1 and a 2 as there's one missing from each side? Very curious!

OK, will do. Just PM me which address to send it to ...

Cheers,

Tom

PM sent.