Any electronics/fuel injection ECU wizards out there?

Post by **pettaw** » 01 May 2005 09:18 pm

MStools2? How does that work? Sorry I've no personal experience apart from reading the manual on the website, with a view to getting myself prepared for installing it so that everything hopefully goes smoothly, so the following comments are only from what I've read.

Because the 800-40ohms thing is so different from the default resistor in the voltage divider, you're apparently going to get a poor resolution over the working range of the circuit, even if you remap the correct temperatures using Easytherm.

Post by **jtbo** » 01 May 2005 09:26 pm

It works pretty much same like Easytherm, you set 3 temps and it calculates map based on those.

I don't know if there is something else involved to that area, but there is plenty of guys that has just made new map.

+1 is around 3500 ohms, and it goes quite high when getting colder, not idea how high anyway.

Post by **pettaw** » 11 Jun 2005 11:12 am

My Ms kit has arrived today! Once I paid the 20 quid dreaded import VAT (humph).

The engine is also going in this weekend. MS won't be ready for a few weeks cos I'll be far too busy to put it together.

Post by **pettaw** » 11 Aug 2005 05:52 pm

Update, MS is soldered together and seems to be working well on the stim. I've now got one stage further, I bought a scrappy ECU to cannibalise the connector, so now a few more components (o2 sensor and tps/air intakes) and a bit of wiring needed.