Faulty propshaft, clutch or gears?

B14, B172, B19/200, D16 engine, ignition, cooling, fuel & exhaust system, gearbox, variomatic, final drive... | Tuning: engine swaps, welded diff, clutch upgrades...
NO parts requests here, please use our V3M BUY & SELL corner
Post Reply
benjileo
Posts: 3
Joined: 13 Sep 2016 08:23 pm

Faulty propshaft, clutch or gears?

Post by benjileo » 13 Jun 2019 12:24 pm

Hi all,

In the last couple days I've noticed a grinding/rumbling sound from underneath the gearbox

When the car is in neutral and the clutch is out there is an audible rumbling that goes away when I push the clutch in.

When changing gears this rumbling becomes more of a grinding sound and is louder the higher the revs - this makes me think it's more likely to be the prop?

I had the clutch replaced less than a year ago. Having done some reading it could be a loose bearing perhaps, but I was told that my prop was looking a little worn last time I took it to a garage, which makes me think it's more likely that.

If it is the prop, does anyone know where I can source one (can't find any on ebay) or perhaps know of other models that will fit the 340?

Cheers,
Ben

User avatar
bogbasic
Posts: 1397
Joined: 21 Nov 2004 10:12 pm
Location: New Malden, Surrey.
Contact:

Re: Faulty propshaft, clutch or gears?

Post by bogbasic » 13 Jun 2019 10:40 pm

Hello, I think the propshaft is unique to the 340 and is very hard to find nowadays. I don't have much experience of propshaft problems, thankfully, so sorry I can't be more helpful in diagnosing the problem.
1988 340 1.4 GL, 218k, 5 door (Grey Bess). Gone to CBA.
1991 340 1.7 GL, 64k, 5 door, petrol blue (Deep Blue).
1988 360 2.0 GLE, 140k, 5 door, ocean blue metallic (Blue Bess).
1989 340 1.7 GL, 108k, 3 door (Red Ness).
More info here!

Ride_on
Posts: 2236
Joined: 26 May 2009 05:34 pm
Location: Belfast, N. Ireland

Re: Faulty propshaft, clutch or gears?

Post by Ride_on » 07 Aug 2019 11:12 pm

You didn't say it was a 340 or a 360. I'm guessing because they can see the prop it is a 340.

The gear box is at the back in any case, if you mean the clutch housing then if its a 340 the clutchshaft bearing might be damaged. There are no moving parts in the 340 prop, it doesn't wear, don't take it back to that place. It does have rubber in it which can give up, but someone has remouded theirs.
1980 345 DL_______1987 360 GLE (project car restored to GLT spec and B230FT'd)
1984 360 GLT______1987 360 GLT
1983 360 GLS______1989 360 GLE
1985 340 GL_______1986 340 1.4
1985 360 GLS______1995 940 SE 2.3 Turbo Estate (daily)
1987 340 GL 1.7

Post Reply