Flexi pipe exhaust ? where from?

Post by **Sam340** » 01 Dec 2006 10:43 am

Is it possible to get flexible piping / hose to use within an exhaust system.... if so where do i get it from?

like this kind of thing

Post by **germ** » 01 Dec 2006 02:44 pm

what kind of thing i cant see the picture

Post by **Sam340** » 07 Dec 2006 06:25 pm

No one got any ideas then........................... The pic is someones car off this site

Post by **pettaw** » 07 Dec 2006 06:26 pm

Its not a 300 series back end. Other than that I dunno. Sorry

Post by **Sam340** » 07 Dec 2006 06:32 pm

Ahaaaaa..... just found origional post......

http://www.volvo300mania.com/forum-uk/v ... e&start=15

It appears to be the Back end of a 760... belonging to V6 Man I think....

Post by **germ** » 07 Dec 2006 07:05 pm

ohhh isee what you mean now

i have seen thoose flexie pipe things in diy shops before and i have seen proper job ones in an exhaust center cant remember which

dont know if this helps

p.s make sure you get a metal one without holes between joints

and there are plastic ones that look like metal so be aware!!

Post by **Bilbo** » 07 Dec 2006 07:07 pm

i got some years ago from andrew page motor factors !

Post by **classicswede** » 07 Dec 2006 08:37 pm

Take a look at the Performance parts cat in the offer section.

I'm sure I sell it

Post by **Ali** » 09 Dec 2006 01:13 pm

Beware it doesn't last very well, i've used it to bodge every single one of my exhaust systems and it works fine but it will rust through quicker than everyone else, i've had to replace mine several times, lucky I got a massive roll of it from a carboot for £2! lol