B14, B172, B19/200, D16 engine, ignition, cooling, fuel & exhaust system, gearbox, variomatic, final drive... | Tuning: engine swaps, welded diff, clutch upgrades...
NO parts requests here, please use our V3M BUY & SELL corner
-
mickt
- *** V3M DONOR ***
- Posts: 177
- Joined: 02 Feb 2005 11:46 pm
- Location: Milton Keynes
Post
by mickt » 06 Nov 2008 12:35 am
Hi ChesterRedline
I had same trouble with my car
I think the cause there could be an air leak at joint between base of carburettor and inlet manifold . At this joint there is a (blue?) heat insulating piece . I was lucky enough to get another inlet manifold from a scrap car and get someone to fit it - then the problem was solved.
It is possible to test for leaks at this joint quite easily
Hope this is of help
cheers mickt
-
ChesterRedline
- Posts: 8
- Joined: 05 Nov 2008 08:22 pm
Post
by ChesterRedline » 06 Nov 2008 01:36 pm
i am sorry but a bit of a novice at cars how wud i test for air leaks the other thing is when i take the air filter off it wont start unless choke is out is this right?
-
340ovlov
- Posts: 186
- Joined: 27 Sep 2008 08:50 pm
- Location: sideways at a roundabout near you
Post
by 340ovlov » 06 Nov 2008 02:20 pm
hi mate it sounds like its drawing air from a seal on the carb best way to test is to get the car running and whilst its doing that spray some carb cleaner around the outer body of the carb if its starts to run right then u have a air leak u can either rebuild the carb or find a scrapper with one in and try that
1985 340 1.4 3door
