Nate wrote:Could you give a cost on the 1.7 diff ?

Cheers

Yeh I could sell the diff but it is welded for drift use!

Ride_on wrote:Any chance of the rubber seal for the steering column into the bulkhead? AFAIK its a standard part on all 300, but not sure.

The rubber around the steering column or the rubber bit where it goes through the bulkhead?

How much for the rear box/diff assembly ?? I can collect !

and id want the welded one

evilmickey6 wrote:and id want the welded one

PM'd

This colour if you have it please

Chris_C wrote:
This colour if you have it please

Yeppp that's the colour I have! I will get a picture tomorrow and post it up!

Are they 3 or 5 door? I'm after door seals for a 3 door.

Hell Driver wrote:Are they 3 or 5 door? I'm after door seals for a 3 door.

3 door mate call it a tenner a door

How much for a prop from the 1.4

cheers

Adam.

13431 wrote:How much for a prop from the 1.4

cheers

Adam.

1.4 prop Is gone

delrio wrote:Yeppp that's the colour I have! I will get a picture tomorrow and post it up!

Any chance of that door picture please bud!

Chris_C wrote:

delrio wrote:Yeppp that's the colour I have! I will get a picture tomorrow and post it up!

Any chance of that door picture please bud!

Yeh sorry will be up here tomorrow

delrio wrote:

Chris_C wrote:

delrio wrote:Yeppp that's the colour I have! I will get a picture tomorrow and post it up!

Any chance of that door picture please bud!

Yeh sorry will be up here tomorrow

How do I upload pictures?

Before I start sending you a wish list......were you planning on coming to the BKV on 16 & 17 June nr Ollerton?

I am actually after the rubber strut mounting tops (the worse they are the better) and perhaps some other bits as well.