how did you get on modifying the rod to fit?

Hello mate i have 2" blocks on my 340 atm but it needs to go lower. could you tell me how low i can go and where i can get some more blocks from ???? thanks

Sam340turbo wrote:Hello mate i have 2" blocks on my 340 atm but it needs to go lower. could you tell me how low i can go and where i can get some more blocks from ???? thanks

3" and try classicswede.com

Still haven't got round to putting my 3" lowering blocks in

Thank for the little support was having a few little issues but after reading the comments everything seems to be fine, just need to get the front springs done now.

What about the centring bolt? surely the axle has the ability to move fore and aft?

The axle in locked in position by the lug on the springs and the locating hole in the bottom plate

I've never been to this site before, but I've got good information. Back to knowledge