nice going Nikdev, it's good to see you back in a 300 again
wish we hade more of those wheels over here all that pops up here is 6x13", that's just too civilized

Will update soon, but for now this will do

Finally getting parts from Dai, that got me motivated so started fiddling with the front setup.
I have decided to try on some coilovers to be united with some spare spindels/nav/Knuckles

The coilover leg is made out of rear nissan s14 coilovers xyz, front s14 top mounts, intrax springs(not sure about the spring rate) and some helper springs




Will explain more later, got some fabrication to do

how is this coming along?

tim-andre wrote:how is this coming along?

This. Show us some new pics Nik!

its sold... Bought a "new" boring car

Got to scared of my drivers license, a tendency to a bit much of inspired driving in wet

And I realized I had become a bit older..

Nooo. Sure you'll have it back at some point. You'll get bored

Nikdev, would you be so kind as to post up any pics you got of your coilover conversion? So many on here looking for coilies, and you look like you had a good idea, did it get finished? how did you manage it? You still got the red one then, or have you left the 300 community? Thomas...............

Attack2001 wrote:Nikdev, would you be so kind as to post up any pics you got of your coilover conversion? So many on here looking for coilies, and you look like you had a good idea, did it get finished? how did you manage it? You still got the red one then, or have you left the 300 community? Thomas...............

I did one conversion one my red 360, and had the same planned for this. But instead of longer turrets witch ain't mot friendly in Norway i was planning to make the coilover body go trough the spindle, much like the work adam has done

Speedy88 wrote:Nooo. Sure you'll have it back at some point. You'll get bored

Hehe, or maybe just save up for a Gt86