pic

Turbo

WOW

Now we made some carbonfiber hoods to the cars 6kg weight.

peter schmidt wrote:Now we made some carbonfiber hoods to the cars 6kg weight.

Sexy.

Are they just one-offs, or did you do a small run of Hoods?

I can do some more hoods.

how much for?

Carbonfiber and epoxi are expensiv so i most have about 400 euro .

You need hole to hood for hood to fit with that turbo?

Are you planning to make airbox for filter to get additional help from wind? I had once with NA motor tube going to foglamp opening so that faster I drove, more air was pushed into airbox, with proper setup that might give some gain.

Yes i have to take upp a hole in the hood. Here is my new steering column i built with 1:2 gearbox ,quick relase and adjustable steering column in height.

Everything is built in alu ,titanium and carbonfiber You can allso se the dash 2 close to the steeringwheel.

Very wide engine

Wow! Superb mate. I am in awe. Good to see these Volvo's getting good attention and some nice parts.

I will have a hood from you, but I am currently saving to have a roll cage made. Can you make them any time?

Thanks, and keep it up! Liam.

I can make them any time

more than great skills to do all that you know what are you doing, i like your 360 a lot!!
i,m going to need a fiber glass bonet too!