classicswede wrote:Now available 360 twin webber manifold

I am interested, does take long to order them? And are all the fitment parts are included?

Do you have a setup for the webers on a b200 with a ported head and a h-kam?

The supply of the manifolds is a bit sparadic but if you can wait a little while I will be able to get one.

The manifold does come complete with studs and gasgets to mount your own carbs. You will also need a new inlet manifold gasket.

Hi Dai.

have you thought about doing some poly bushes for the 360 tranny? You know, the ones that the tranny+diff is suspended in!
I have bought the last two in from Volvo in Denmark and they don't make them anymore

Just a thought

Regards.
Peter

Hi Peter,

thanks for your thoughts. I have thought about - now that Volvo have stopped making them I think I will have to press on and get them done.

Hi again Dai.

SUPER

I think that making them in the poly bush material will make a great upgrade to the std. rubber that the originals are made of!
My tranny + engine has the tendency to "wobble" a bit when engaging the clutch! With some poly bushings for the tranny and some poly bushings for the engine mounts

Also in the near future I'm about to make a overhaul on my GLT!
For this overhaul I'll gonna need some of your bushings!

Regards.
Peter

Have you read my MPs Dai ?

Cheers !

Just thought I'd pop up a pic of my car with Dai's lowering blocks and springs fitted.



Fitting was simple because I got Josh to do most of it, but we did find that the bolts supplied with the blocks were no good. The unthreaded part was too long, so the nuts could not be tightened up enough.

As you can see, my engine splash guard is not going to last long!

how low is that?




Cheers
will

"2 blocks, -3" springs

wow love your new avatar too



Cheers
will

Nice to see another o ne lowered

Sorry about the bolts - I ended up with some loner than they should have been for some reason - all sorted now.

Hi

If i was to order exhaust parts how long would it take for them to be delivered - and cost?

Hi Dai,

Have you reciveed my Cheque yet for a set of blocks?

Regards,

Mark

Just wondering if you have rear poly engine mounts as well as the front?

If you dont, anyone know where to get some?

Hey dude, as per PM don't suppose you have any engine mounts available again have you matey? If not, I can pay to order if your close to ordering anyway, really want some lol!