I need dimensions from a Leo centre cap, fairly pronto. Can anyone help?

It's a long term project, but stage 1 might need to happen in the next week or so. I have no idea what the back side looks like, so currently I can't say which dimensions I need. If someone has a photo of one, I'm happy to photoshop on the dimensions required for that person to fill out again?

Ta all

IIRC it's 56 mm wide. I can get a pic up for you soon ...

Cheers

Tom

I could send you a few if you want? I've got a tub of them in the garage somewhere!

Ooh Theo, one for me too please

Cheers

Tom

I'd appreciate that please Theo, I'm going to make some reps (in standard Chris time before anyone gets excited!) as mine came with none and I can't get them anywhere!

Do you need my address? I'll check if I still have your paypal

OK, here're the pics:







approximate dimensions
inner ring: 56mm approx
outside, from rim to rim: 61mm approx
outside, the black part: 42 mm approx
height of the "V": 17 mm approx
length of the "V" (measured at the top): 32 mm approx

Not much help for a reproduction run, I'm afraid ...

Cheers

Tom

Gives me some numbers to work with Tom, thanks

With those moulding pips... they are plastic?! That might make life easier and harder all at once..

Yes, the whole thing is plastic... No steel anywhere!

Cheers

Tom

Chris_C wrote:they are plastic?!

Course they're bloody plastic Chris! Whaddaya think they were? Steel billet?

Mine were/are going to be ally billet!

Flipping cheapskate Dutchies

These look like they good fit going of Toms dims

http://www.ebay.co.uk/itm/VOLVO-Alumini ... 4d06e56ba4

Can I order a set for when I might buy a GLS in 5 years time, should be just about ready by then?

Chris_C wrote:Mine were/are going to be ally billet!

Flipping cheapskate Dutchies

Im sure plastic would be better. You should look into 3d printing, this is applications that could be suited to 3d printing. Low run batch. The best way would be to get one 3d scanned giving you an SLA file (I think) that could be used for the 3d printer

That was another thought, I finished a Huxley yesterday Really very impressed so far.

Chris_C wrote:That was another thought, I finished a Huxley yesterday Really very impressed so far.

Im sorry chris?