I need a front valence outer panel for a late 340 i.e. With the flat part for a number plate. Its rusted through and the welder can fabricate it but we thought we'd ask in case...

Hey, I have a new mk2 front valence, but it is going to be sent off to get a fiberglass mold off it, also sending off the hump bit from a mk3 to get mk3 ones made too, does this help?

Ben

I have been looking for one for the past 4-5 months and am still on the lookout for a 86-91 360 valance (hump and spotlight holes).
A GRP version will not do for me as it is classed as a structural part of the car over here...

I've got one on the car im parting at the moment, but I'm a little far away. Like. The other side of the planet.

I know, I read your post.
But the shipping that you are quoting:

Logan360 wrote:I would plan shipping at about £900-£1000 for shipping.

makes it a wee bit too expensive, a panel beater can work quite a while for 1100 euro (£1000, one thousand Sterling) I guess.

Otherwise it would have been tempting

The onderdelen place does early model ones for 175 euros so a fibreglass addon for the numberplate might do the job??

That postage is for the front half of a car, torque tube, bell housing, 2x front Cross members, 2x gearbox crossmembers, and a couple hundred kg of more parts like electric mirrors and power windows etc