Page 1 of 1
beemer alloys??????
Posted: 09 Sep 2005 01:51 am
by robbieg
anyone know if these will fit a 340? + what could you do about the centre caps, spray them?
http://cgi.ebay.co.uk/BMW-13-cross-spok ... dZViewItem
Posted: 09 Sep 2005 08:00 am
by redline
I cannot find any reference to e21 fitment ,as far as I know its only the E30 series wheels that are 4x100, as you are so close cant you email the guy and ask to try one on the car ? If the stud pattern fits , once they are on check carefully for clearance at the back of the rim i.e. between tyre and suspension parts so there is no chance of fouling or rubbing I tried one set of bmw wheels on my 300 and because of the offset (distance between the centre hub and rim) they were no good( to close to front strut ) , A good ebayer will let you try them on
Posted: 09 Sep 2005 08:34 am
by Thomas D
Like it says, will fit on any 4-stud BMW, so it has to be 4x100. The picture tells, offset is 18 (ET18). So they will stick out more than a Volvo rim, you have no problem on the inside. In return, depends on how wide the tyres are, they could rub on your fenders. As long as they are 175 or less, you should be OK.
Posted: 09 Sep 2005 08:43 am
by Thomas D
I remember fitting 205 on ET25 rims once. In front, there was no problem, at the rear axle, it was very, very, close to the fender when the trunk was full.
The tyres on ebay seem to be 185, so compared to my experiment, you are 3 mm more on the safe side. As long as your car is not lowered, it should fit, but it is a very close fit !
Posted: 09 Sep 2005 08:45 am
by Thomas D
And get some stickers on ebay for the center caps.
You should have enough info by now

Posted: 09 Sep 2005 08:53 am
by redline
they do look kool , almost as nice as my rims LOL
Posted: 09 Sep 2005 09:01 am
by redline
Posted: 09 Sep 2005 03:23 pm
by robbieg
thanks for the info guys, yea im going to get em, they do look cool, problem is that i really want to lower the car ,alot. but ill cross that bridge when i come to it! i may have to roll the archres to get some clearnce or just wait a year and get some low profiles when i need them.
Posted: 13 Jan 2006 06:19 am
by deleted
hmm, i thought e21s had a different stud pattern
i used to have one and my mate has one, this is whathe told me.
but never tested it :)
Posted: 15 Jan 2006 01:48 am
by Black_360_GLT
All E21s were 4x100pcd, and all E30s bar the M3 were the same fitment. I think your mate was on about the offset on his E21 which IS unique to the E21 (18mm offset).
Some 15inch BBS BMW crossspokes from an E30 3 series with volvo badged centre caps of course would look very nice on a 300.
Regards,
Al
Posted: 15 Jan 2006 11:48 am
by SteveP
I've thought the same, but isn't the offset quite different?
Posted: 15 Jan 2006 11:28 pm
by Black_360_GLT
Oops, yes Steve you are right, they have a lower offset 15..25 so will not fit a 300. There are many other 4x100pcd wheels that will fit from other cars though.
Regards,
Al