• Probably the fastest 1.7T conversion I've seen

Posted: **13 Nov 2006 06:39 pm**

This one Finnish guy planted a 1.7T in his 340, got the engine at 21st of October and now everything is quite finished.

And now it's proven that 1.7T will fit in even without rotating the turbo..

Well he is not running intercooler yet so he left it currently that way, to keep every cost minimum as possible. Quite nice work with such a low cost in such a tight time scale.

Those are few week old pics, he hasn't upload the latest ones yet.

It's his second engine swap in that car, first he had 1.4 which he changed to 1.7 some time ago and now he swapped to 1.7T.

Posted: **14 Nov 2006 01:37 am**

Excelent

Can you try to get more pictures, especially of the inlet manifold?

Posted: **15 Nov 2006 01:43 am**

Looks like the inlet would foul RHD, but fits LHD nicely. Good work that man!

I do hope that picture of the gold coloured object isn't what I think it is - an electric carb (low pressure) fuel pump, and a cheap one at that!

cheers

James

Posted: **23 Nov 2006 11:03 pm**

foggyjames wrote: I do hope that picture of the gold coloured object isn't what I think it is - an electric carb (low pressure) fuel pump, and a cheap one at that!

James

That's just currently working as a "transfer pump" to get the fuel out of the tank, pressure pump is in the engine bay.

The car is running now and working fine. It took few extra days because first the car didn't start. All injectors were jammed.

He got new injectors today and now it's running.

He said he's posting more pics and vids tomorrow and more specific specs what all had been changed.

Posted: **24 Nov 2006 11:36 am**

foggyjames wrote:Looks like the inlet would foul RHD, but fits LHD nicely. Good work that man!

I do hope that picture of the gold coloured object isn't what I think it is - an electric carb (low pressure) fuel pump, and a cheap one at that!

cheers

James

The inlet to be perfect asto be modified, because it almost hits the brakes servo.

I would like to see pictures of the job done in the inlet..

Posted: **26 Nov 2006 12:50 pm**

He just made a simple adapter pipe to turn the inlet of the intake manifold

http://koti.mbnet.fi/zuppo/kuvat/volvo/ ... 000469.jpg

The car is up and running, he said that the idle is still a bit lumpy for some reason but other than that it pulls fine and much better than the NA engine..

Posted: **26 Nov 2006 08:09 pm**

Thanks for the photo

It looks ok

Other way: