hello everyone i finally fitted my exhaust hope u like it if not then go to HELL!!!!! LOL





there u go and some people said it wouldn't look good LOL

Looks better than I imagined actually hehe

Matt

thanks for the comment i didn't expect to it to look that good either but it looks different I'M NOT A SHEEP!!!!!!!! LOL

Exelent very cool

its even better than i expected and i thought it would look good

Well done.



Cheers
will

It's actually a bit of a shame that the rear valance panel is curved, as it suits the boxy lines apart from that curve It has turned out better than I expected - and it's growing on me as I look at it. Just put another one on the other side now

No reference to the exhaust specifically, but over the years various automotive sins have been covered by "daring to be different". While, of course, we don't want all the cars to be the same...'different' is used as justification for "looks like arse" far too often.

cheers

James

looks trick
thanks
lee

Yeah, if the valance wasn't curved would look ace, but I'll stick with good

If nothing else that one hasn't got minilites, so its got to be a good thing

Whats planned now Josh?

just some lowering i think and maybe an engine conversion next summer

Hmm, well, as always I fail to see point, but if you like it then it is good

If it does not give improved performance then it is pointless is my philosophy, so you better just ignore me

Josh_Cohen wrote:just some lowering i think and maybe an engine conversion next summer

what engine?
thanks lee

It doesn't look too bad, being different doesn't hurt and if at the end of the day you like it, that's all that matters! Maybe if it came out at a slight angle so it wasn't square to the back of the car, but was protruding the same amount from the valance it would add to it.

Lucky chap having a ramp to use too. That would be nice to have, it'd make life a lot easier!

Pete

Excellent job, thats looks pretty damn cool!!

As other have said it's a shame about the curved valance - perhaps you could graft some sort of lip on the bottom of the bumper to square things up and cover the green valance - I reckon that'd tidy things up nicely.

Shockingly bad butchering of your photo, but something like this:

Carls just managed what I thought about when I saw the ebay photo!

A modified bodykit valance would do it.

cheers

James

I have to say as it is I personaly do not like it but I can see whith a change of rear bumper or valance it would work very well.

Nice to see something different though