340 2 inch lowering blocks and 2 inch drop springs brand new

Post by **turbopete** » 07 Dec 2007 07:03 pm

right these have just arrived and there already for sale! brand new I just want what I paid for them! £90 I'm in derby area and sometimes hull area any questions just ask!

Post by **foggyjames** » 09 Dec 2007 07:05 pm

Did the front springs come from Dai? If so, I bet they're rated for a 340, rather than a 360. Potentially keen though...

cheers

James

Post by **classicswede** » 10 Dec 2007 02:00 pm

James If you want to slam the front of a 360 they will be fine.

There ideal for a 1.7 (touch stiff for a 1.4) but will work fine on a typical 360.

Post by **Bobalob** » 10 Dec 2007 06:50 pm

intrested as these for my 1.7 340

Post by **foggyjames** » 12 Dec 2007 08:07 pm

I don't want to drop the 360 too far. Perhaps best for someone with a 1.7 then

cheers

James

Post by **turbopete** » 14 Dec 2007 11:05 am

bump and a price drop to £75

Post by **magnumpi** » 08 Feb 2008 01:26 am

Presume these have sold by now?

If not i have cash and can pick them up at the weekend if any good to you?

Also sent PM

Post by **classicswede** » 08 Feb 2008 01:55 pm

I take it you have a 1.7 in need of lowering?

Post by **magnumpi** » 08 Feb 2008 11:16 pm

No Dai, i've got a 1.4 3dr, so are they not suitable for what i require?

Post by **classicswede** » 09 Feb 2008 01:20 pm

They will be ok with the 1.4 just slightly stiff but not enough to worry about. If you want the real low look you may want to trim the length down an inch either end to make it sit as a 1.7 would. If Pete still has them it would be worth the saving.

Relised its you with lowering questions in general discussion

Post by **magnumpi** » 09 Feb 2008 04:44 pm

LOL yes it is i , see i told you i'd be asking lots of Q's

Does anyone happen to know Turbopete in the real world, i.e not just on the forum?
Maybe you could give him a nudge and let him know i want his parts?!

Cheers

Post by **classicswede** » 10 Feb 2008 11:57 am

He may be on drift works??