howdy doody all

im hopeing that some of you can help me with this lil problem

as some of you know i have purchased a set of weber DCOE 40's off steve

but im having problems getting hold of an inlet manifold as i have a 340 1.7GL where as if i had a 360 it would be (in the words of the meerkat on that advert) simples lol

i have sent classicswede a pm for help

but im wondering if anybody is able to give me any help on the situation?

cheers

None available off the shelf as far as I know. You may have to go custom, sorry to bring bad news.

Was meant to PM you again Lee as I thought of Bogg Brothers up't north I think...

I've heard their name mentioned a few times when it comes to building custom manifolds for IRTB's and bike carbs for use on carbs. I reckon they'd be able to make something up for you! They're supposed to be very reasonable too!

£175 for new applications typically.

They are quite good, my mate had a mani made up for a corsa sport that and the bikes carbs cost around £250 think they even sort of tuned them up. corsa driver = fail he blew the engine on the way home.....there is only one word and james may sum's it up quite well

Yeah if you're used to a rev limiter it can be hard to watch the tacho. Sure I hit over 8k rpm on the way to the test centre today.

Eeeeasy there Cheesey.

SteveP wrote:Was meant to PM you again Lee as I thought of Bogg Brothers up't north I think...

I've heard their name mentioned a few times when it comes to building custom manifolds for IRTB's and bike carbs for use on carbs. I reckon they'd be able to make something up for you! They're supposed to be very reasonable too!

yea a few people have mentioned them so am gunna give them a buzz but am hopeing that there are more suggestions out there that people can think of

cheers peeps

bogg brothers are the men for the job round our way everyone use's them for manifold's they seem to be the kings of n/a tuning to