Page 1 of 1

wheels, momo seat, lots of stock parts.

Posted: 21 May 2009 04:12 pm
by dez
1. pair of 7x13 minilites. mini bolt pattern contrary to what some people say, they dont fall off if you use em on a 300. 195/55r13 pirellis, not really road legal but would be ok for the track.
flakey laquer on the dish but no kerbing, only a couple of minor scuffs.
£75
Image

2. pair of 7x13 alleycats. mini pattern again.
again, a couple of minor scuffs but no kerbing, need a good clean though!! one 175/50r13 with about 4mm of tread, no tyre on the other.
£75
Image

only selling the above as im now running 13x8 and have redrilled to ford pattern on the rear!

3.momo course seat, model- 'start'.
black, FIA approved (dated 2001), fiberglass/polymide shell. 2 tiny nicks in cover, one on fornt corner one on the back that cant be seen unless you turn the seat upside down. very good condition, really deep sided, and nice and light.
red securon 3 point harness, seatbelt buckle type, with second seatbelt buckle quick-release behind seat. only selling as ive gone to a kirkey and 5 point nascar style harness.
£85 for seat and harness.
Image

4. stock b14 engine, with all ancillaries except starter motor. has bellhousing and clutch on still, rad, pipework etc. all included.
has done 70k and has recently had a full service done by previous owner just before i bought the car a few months ago, only done a couple of thou since- plugs, oil, filter, dizzy cap, etc. and i put on points and condensor about a month ago. has a weber carb on it.
just removed to go F7P.
good engine that drives nice.
£50

i also still have a lot of bits from a '89 1.7 i broke recently- ask if theres anything specific you need.

all items located in colchester.can post the postable items at cost, or get items taken to north london (islington/angel area) or eye in suffolk if thats any help.
07813289931
ddmetalworks@ hotmail.com

Re: wheels, momo seat, lots of stock parts.

Posted: 22 May 2009 01:58 pm
by littlered
how about a bonnet?

Re: wheels, momo seat, lots of stock parts.

Posted: 22 May 2009 02:57 pm
by magnumpi
If your strugling to get a bonnet, do you know where Bridges breakers yard is?

It's not that far from you, down the M25 then the m23 or whatever it is that goes to Brigthon, come off at the Pease Pottage junction and its there, they usualy have at least one 340 in.

Or give them a ring to check 1st, you can find their number here: http://www.gwbridges.co.uk/index.html

Re: wheels, momo seat, lots of stock parts.

Posted: 22 May 2009 03:02 pm
by Chris_C
Non there on Monday :(

Re: wheels, momo seat, lots of stock parts.

Posted: 22 May 2009 04:00 pm
by dez
sorry no bonnet, it was damaged. i do have other panels though, doors and wings, if anyone needs them.

Re: wheels, momo seat, lots of stock parts.

Posted: 30 May 2009 11:12 am
by dez
seat now sold, harness still available though.