Page 1 of 1

breaking 480 turbo

Posted: 07 Dec 2009 01:00 pm
by kickasskez
hi guys

i am currently breaking a volvo 480 turbo. loads of parts available car has only done 62k but was in a small crash damaging the drivers wing and door. bought it cheap off a friend so i could use the engine in my 340 gle. therefore engine and loom are already out but everything else must go.

can contact me on here or on 07999349342

cheers
kieren

Re: breaking 480 turbo

Posted: 07 Dec 2009 02:01 pm
by Chris_C
Not that I want it, but it's worth grabbing the sensor in the front grill, it's the same as the 300 ambient temp gauge one!

Re: breaking 480 turbo

Posted: 07 Dec 2009 02:44 pm
by volvosneverdie
Chris_C wrote:Not that I want it, but it's worth grabbing the sensor in the front grill, it's the same as the 300 ambient temp gauge one!
Good spot Mr C.
I'll have the Amb Temp sender if youve got one mate.
Pm me price.

Re: breaking 480 turbo

Posted: 07 Dec 2009 03:36 pm
by Chris_C
No worries ;) You also require 6-12" at least of loom and plug mate, then you can just make up a spade to spade lead to plug it into the 300.

Re: breaking 480 turbo

Posted: 07 Dec 2009 03:49 pm
by volvosneverdie
Chris_C wrote:No worries ;) You also require 6-12" at least of loom and plug mate, then you can just make up a spade to spade lead to plug it into the 300.
Wirings in, just need sender. Unless 400 senders need different wiring??

Re: breaking 480 turbo

Posted: 07 Dec 2009 04:13 pm
by Chris_C
Shouldn't be, but from memory 300 wiring finished at a 1/4" spade so I've always needed to take the a bit of 400 loom as well. I'm not sure whats been done to your car though mate!

Re: breaking 480 turbo

Posted: 11 Dec 2009 11:03 am
by kickasskez
hi sorry i havent been on in a while
i shall try get the sensor out do you know the exact location of it?

Re: breaking 480 turbo

Posted: 11 Dec 2009 02:54 pm
by kickasskez
i have the sensor you are after make an offer mate