Valver conversion parts

[billkent22]

Right im doing quite well with collecting these conversion parts for my valver conversion however.... I am desprate for the following:

• Gearbox mount
  Front engine mounts (BOTH)
  1.7 Bellhousing bolts
  Valver oil cap (not so important but still need)

If you have any of th above PLEASE PM me!

Bill

[billkent22]

Bumpety bump bump

[jon-ovlov]

I think i've got a couple of gearbox mounts somewhere. Still need them?

[billkent22]

Thought i could use the 1.4 ones, as they do fit on?

Bill

[filthyjohn]

Yeah you can, but you asked for one above ^^^

[billkent22]

Yeah you can, but you asked for one above ^^^

YES! good call, im such a knob!

In that case thank you for getting back to me but i dont need the g/box mounts

[billkent22]

Right managed to source a few bits but still in need of:

1700 Sump
1700 bellhousing bolts (unless anyone can tell me the sizes)
Fuel pump
Oil cap for valver lump
1700 Alternator bracket

Event though i have found a few bits the list is now longer!

[Alex Laidlaw]

The 1.7 bellhousing bolts are:

M10 x 1.5 grade 8.8 or better (important!) hex headed

3 x 125 long, thread length 30
1 x 90 long, thread length 27
1 x 55 long, thread length 29

[jon-ovlov]

Alex, I'll put those values in my guide if that's cool with you mate. (cripes, STILL haven't finished it! )

[billkent22]

Thank you for your help!

[billkent22]

Right I have managed to collect most of the parts i was after but I just need one part:

Front engine/Sump mount

[billkent22]

K now after a renault renix!

Billo