how to fit rear lowering blocks

[benthompson]

how did you get on modifying the rod to fit?

[Sam340turbo]

Hello mate i have 2" blocks on my 340 atm but it needs to go lower. could you tell me how low i can go and where i can get some more blocks from ???? thanks

[Evoman]

Hello mate i have 2" blocks on my 340 atm but it needs to go lower. could you tell me how low i can go and where i can get some more blocks from ???? thanks

3" and try classicswede.com

[S14x]

Still haven't got round to putting my 3" lowering blocks in

[EDY.340]

Thank for the little support was having a few little issues but after reading the comments everything seems to be fine, just need to get the front springs done now.

[CrawlerCarrot]

What about the centring bolt? surely the axle has the ability to move fore and aft?

[classicswede]

The axle in locked in position by the lug on the springs and the locating hole in the bottom plate

[Macoton]

I've never been to this site before, but I've got good information. Back to knowledge