Ok i need a lot of body panels, ive tried on here and ALOT of my local scrappys and cant find a mk2 to be able to rob bits off and the one I did find the panels i needed were rotten, missing or dented.

So I need to ask if anybody knows any mk2's being broken OR if anyone knows a specalist who could help?

I need:

2 x Front anti roll bar cups that the bushes sit in
1x mk2 drivers wing OR pair of front wings if not mk 2
1 x Long slim body panel that sit above front bumper and below the grill
1x strengthning bar that sits under the roof between the b pillars.

Need some of these parts asap as there holding up the build a bit

I have a reasonable condition "slim" panel which I can bring at the weekend...£10? I forget the exact condition, but it's not rusty to the point that it's in two pieces yet!

The only differences between mk2 and mk3 wings are the holes for the indicator repeater (missing on mk3 - repeater in bumper) and mounting bracket for the "slim" panel (again, missing on mk3). Finding mk3 ones will be a lot easier...

cheers

James

Id rather keep to mk2 bits BUT if mint mk3 bits are available i wont say no.

Could you get me a pic of that slim panel?

Not easily (it's at the unit with the ARB), but I can bring it with me at the weekend...then you can see whether or not you want it. No obligation!

cheers

James

yes please..mines not bad but will need more work to get sorted so im sure yours cant be any/much worse.

yes please bring it if you dont mind along with the arb and those cups for the arb bushes if you have them.

oh could you msg me your number again? ive deleted a load of msgs and think one was yours

Might help if you said whereabouts you are

Yes good point

Im near Oxford

foggyjames wrote:I have a reasonable condition "slim" panel which I can bring at the weekend...£10? I forget the exact condition, but it's not rusty to the point that it's in two pieces yet!

The only differences between mk2 and mk3 wings are the holes for the indicator repeater (missing on mk3 - repeater in bumper) and mounting bracket for the "slim" panel (again, missing on mk3). Finding mk3 ones will be a lot easier...

cheers

James

If I go MK3 wings does that mean I wont need a long slim panel? Or can i bodge the slim panel on there?

Basically if i go Mk 3 wings do i also need to use a mk3 bumper?