i had a thought about putting a single bike carb(40mm) on a moded 1.7 manifold,

would it be possible and would there be a power increase?

1.7i project fell though

Cheers
will

I doubt you will get any power increase with a single carb. If you had a manifold made to take two then I can see a possible flow improvment.

Whats gone wrong with the 1.7i Project? I may have soem of the bits you need.

For what it's worth wouldnt you be better off getting a full bank of four and have a custom fannimold made up by somebody like Boggbros?

There cheap enough anyway. Unless your working on a specific budget??

cheap as poss my dad basically told me not to touch my engine unless it blows up...... coz i was going to fi it got the engine and found the head was warped and the bodie was worn out,

thinking 1.8spi from laguna again now.. just waiting for my engine to give it up

problem its solid as a rock hence the bike carb idea to solve the fueling problem.
specs of 1.8spi not bad... on fuel econ.

Max Power (bhp/rpm)
95/5750
Max Torque (lb ft/rpm)
104/2750
Town mpg
25.2
Out of Town mpg
35.3
Average mpg
44.8
Fuel

Will

I had a 2.0 laguna and it went quite well for a big lump of france. Probably the same block as the 1.8 and there should be no price difference by now. Correct me if I'm wrong...

Its the same as the 440 bar the manifolds etc. The 2ltr is a good lump - its been great in vickys car.

germ wrote:just waiting for my engine to give it up problem its solid as a rock

Drain the oil out - rev it to f**k, and then when it blows up you can shout "Dad! I need a new engine..."

^^

worth a try

btw interesting my car dynoed 110hp...but its a fake figure theres a big fiddle going on in france, found out iam making around 93hp's






(damn fr@#s)

Why not close up a couple of the plugs and put some oil in the petrol - that will make the engine seem buggered without actualy killing it!

so, the 2.0 lump from the laguna makes 5hp more than the volvo mhhh, and it will drop stright in with out intake issues ie throttle body right in the air box bit? there will be room to put a air filter?

my dads acording the swap aslong as i dont ask him for any help and pay for it myself

Cheers
will

You need the early 440 injection inlet manifold or a carb.

The normaly 440 manifold could be used but the heater box would have to removed to make it work.

this is she manifold you want

Why not swap the EFI parts onto the existing engine? If you can't swap engines, I'd either go EFI, bigger downdraft carb, or venturi-per-pot carbs like DCOEs or the bike carbs.

cheers

James

wait a sec what efi/size engine is that


Edit* thanks for the piccies too, need to know the year for that too


Cheers
will