As some of you know I want to remove a reverse lense from a fucked unit and refit it to my good one.
I stuck it in the fan oven earlier at around 90* for under 10 minutes (including oven warming up) and here's what happened

Good thing I cut off a practice section first! The 'glue' hasn't even budged BTW.

The hair dryer technique doesn't work either. It almost seems like the lenses are superglued to the body :/ There is no evidence of any bonding like you seem to get with other make lights


All I can think now is plan B. Cut the lense out with a Dremmel.

Any other suggestions?

i really didnt think youd actually try cooking it man.

Have you tried fitting it to a car and slamming the boot?

Seems to work 7 times out of ten.

Have a pop with the Dremel, just make sure no one is behind you to give you a nudge when you least need it...

I don't know about the tail lights, but the front blinkers are heat-glued together. At least the plastic is melted.

volvosneverdie wrote:i really didnt think youd actually try cooking it man.

Have you tried fitting it to a car and slamming the boot?

Seems to work 7 times out of ten.

pmsl

Might sound silly but, cheese wire? I can imagine it would sink right through glue.

Hi mate.
If nothing else works,you could always put some gravy on the lights,boil a couple of irish spuds
and have lot for dinner.
Cheers Mark.

dude y don't you just have the light I offered u a few months ago!!

Dremel.

cheers

James

Cheers all. J430GLT. I never got a reply from you dude. I assumed you had sold it.
Maybe my reply never sent! Gay.

huh?? i sent you a message, u still want it?